振動臺法實驗裝置是**檢測儀器，按照公路土工試驗規程標準研制，振動臺法試驗裝置用于測定無粘性自由排水粗料土、巨料土、（包括堆石料）的大干密度，本產品的大密度，本產品具有結構緊湊，振動臺法試驗裝置使用方便等優點，廣泛用于施工現場實驗室及科研單位。

The vibrating table method experimental device is a professional testing instrument developed according to the highway geotechnical test standard. The vibrating table test device is used to measure the dry density of non-adhesive free drainage coarse soil, giant soil, and (including rockfill). The large density, this product has the advantages of compact structure, convenient use of the vibration table test device, and is widely used in construction field laboratories and scientific research units.

振動臺法實驗裝置技術參數:

★采用變頻器，數字控制

★振動臺面尺寸：600x600mm（公路標準） 762×762mm（鐵路標準）

★頻率振動：0---60HZ可調

★雙振幅：0---2mm可調

★外形尺寸：470X280X880mm

★重量：100kg

Shaking table method experimental device technical parameters:

★Use inverter, digital control

★ Vibration table size: 600x600mm (road standard) 762 × 762mm (railway standard)

★ Frequency vibration: 0---60HZ adjustable

★Double amplitude: 0---2mm adjustable

★Dimensions: 470X280X880mm

★ Weight: 100kg

振動臺法實驗裝置試驗方法（干土法）

★充分?jǐn)嚢韬娓稍嚇樱词蛊漕w粒分離程度盡可能??；然后大致分成三份。測定并記錄空試筒質量。

★用小鏟或漏斗將任一份試樣徐徐裝入試筒，并注意使顆粒分離程度?。ㄑb填宜使振畢密實后的試樣等于或略低于筒高的1/3）抹平試樣表面。然后可用橡皮錘或類似物敲擊幾次試筒壁，使試料下沉。

★放置合適的加重底板于試料表面，輕輕轉動幾下，使加重底板與試樣表面密合一致。卸下加重底板把手。

★將試筒固定于振動臺面上，裝上套筒，并與試筒緊密固定，將合適的加重塊置于加重底板上，其上部盡量不與套筒內壁接觸。

★設定振動臺法試驗裝置在振動頻率50Hz下的垂直振動雙振幅為0.5mm；或在振動頻率60Hz下的垂直雙振幅為0.35mm。

振動試筒及試樣等，在50Hz下振動10min；在60Hz下振動8min。振畢卸去加重塊及加重底板。

★按本規程2-5步驟進行二層、第三層試料振動壓實。但第三層振畢加重底板不再立即卸去。

★卸去套筒，然后檢查加重底板是否與試樣表面密合一致，即按壓加重底板邊緣，看其是否翹起，若翹起則宜在試驗報告中注明。

★將百分表架支桿插入每個試筒導向瓦套中；刷凈試筒頂沿面上及加重底板上位于試筒導向瓦兩側測量位置所積落的細粒土，并盡量避免將這些細粒土刷進試筒內，然后分別測讀并記錄試筒導向瓦每側試筒頂沿面（中線處）各三個百分表讀數，共12個讀數（其平均值即為終了百分表讀數Rf）。

★卸去加重底板，并從振動臺法試驗裝置面上卸下試筒。在此過程中，盡可能避免加重底板上及試筒沿面上落積的細粒土進入試筒里。如這些細粒土質量超過試樣總質量的0.2%，應測定其質量并注明試驗報告中。

★在合適的臺稱上測定并記錄試筒及試樣總質量，扣除空試筒質量即為試樣質量，或仔細地將試筒里試樣全部倒入已知質量的盤中稱量。計算大干密度dmax。

★重復1-10步驟，直至獲得一致的大干密度值（好在2%內）。如果發現產生過分的顆粒破碎或者是有棱角的石渣、堆石料或風化弱巖石料，則宜盡量制備足夠數量代表性試樣，以避免單個試樣重復使用。;濕土法，結果整理、壓實指標計算請參照相關規范。

Shaking table method experimental device test method (dry soil method)

★ Stir the sample thoroughly, even if the particle separation is as small as possible; then roughly divide it into three parts. Determine and record the mass of the empty test tube.

★ Use a spatula or funnel to slowly put any sample into the test tube, and pay attention to make the particle separation degree small (filling should be equal to or slightly lower than 1/3 of the height of the tube) The surface of the sample. Then, the test tube wall can be tapped several times with a rubber hammer or the like to sink the sample.

★ Place a suitable weighted base plate on the surface of the sample and gently turn it a few times to make the weighted base plate conform to the surface of the sample. Remove the weighted base handle.

★ Fix the test tube on the vibration table, install the sleeve, and fix it tightly with the test tube. Place the appropriate weight on the weighted base plate, and the upper part should not touch the inner wall of the sleeve as much as possible.

★ Set the vertical vibration double amplitude of the vibrating table test device at a vibration frequency of 50 Hz to 0.5 mm; or the vertical double amplitude at a vibration frequency of 60 Hz to be 0.35 mm.

The vibration test tube and the sample were vibrated at 50 Hz for 10 min; at 60 Hz for 8 min. After the vibration is removed, the weighting block is removed and the bottom plate is added.

★ Perform vibratory compaction of the second and third layers of samples according to steps 2-5 of this procedure. However, the third layer vibrating the base plate is no longer removed immediately.

★ Remove the sleeve and check whether the weighted bottom plate is in close contact with the surface of the sample. Press the edge of the bottom plate to see if it is lifted. If it is lifted, it should be noted in the test report.

★ Insert the dial indicator rod into each test tube guide sleeve; brush the fine-grained soil accumulated on the top surface of the test tube and on the weighted bottom plate at the measurement position on both sides of the test tube guide tile, and try to avoid These fine-grained soils are brushed into the test cylinders, and then each of the three dialect readings on the top surface of the test-tube (on the centerline) of each side of the test-tube guide is read and recorded, for a total of 12 readings (the average is the end) Dial indicator reading Rf).

★ Remove the weighted base plate and remove the test tube from the surface of the vibrating table test device. In this process, it is avoided as much as possible to increase the fine-grained soil deposited on the bottom plate and along the test tube into the test tube. If the quality of these fine-grained soil exceeds 0.2% of the total mass of the sample, the quality should be determined and indicated in the test report.

★ Determine and record the total mass of the test tube and the sample on a suitable table scale. Deduct the mass of the empty test tube to determine the mass of the sample, or carefully pour all the samples in the test tube into a known quality plate. Calculate the large dry density dmax.

★ Repeat steps 1-10 until a consistent large dry density value (better within 2%) is obtained. If excessive particle breakage or angular gravel, rockfill or weathered weak rock material is found, it is advisable to prepare a sufficient number of representative samples to avoid repeated use of the individual samples. Wet soil method, the results of finishing, compaction index calculation, please refer to the relevant specifications.

振動臺法實驗裝置其它配套工具（由用戶自配）

★百分表及支架：表分表量程至少50mm以上，分度值0.025mm

★臺稱：量程50Kg，感量6g

★起吊機：起吊重量至少180Kg

★標準篩：60mm; 40mm; 20mm;10mm; 5mm; 0.074mm

★其它工具：加厚底板提手、烘箱、金屬盤、小鏟、大勺及漏斗、橡皮錘、秒表、直鋼尺、試筒布套等。

Vibration table method experimental device other supporting tools (self-matched by the user)

★ Dial indicator and bracket: the meter scale is at least 50mm, and the index value is 0.025mm.

★ Taiwan scale: measuring range 50Kg, feeling 6g

★ Lifting machine: lifting weight is at least 180Kg

★ Standard sieve: 60mm; 40mm; 20mm; 10mm; 5mm; 0.074mm

★ Other tools: thick bottom handle, oven, metal plate, spatula, large spoon and funnel, rubber hammer, stopwatch, straight steel ruler, test cloth cover, etc.

振動臺法實驗裝置試驗完畢，請將試筒及振動臺法試驗裝置表面清理干凈、作防銹處理后，罩上防塵專罩。

After the test of the vibrating table method experimental device is completed, please clean the surface of the test tube and the vibrating table test device, and rust-proof treatment, and then cover the dust-proof cover.